Mechanical safety comes before SWR:
The CHA 34HD REDUCER KIT is the missing mechanical interface between the narrower CFM-34HD base and the 3-inch CHA PORTA-MOUNT family. It keeps the mast centered and supported instead of letting a high-leverage field system ride loosely in an oversized mount.
Stop-work conditions
- Do not raise a mast if either sleeve is missing, loose, cracked, or not fully seated.
- Do not overtighten and deform the mast.
- Control the fall zone and use the required guying.
- Lower the mast before removing the reducer or mount restraint.
Control wind, leverage, and movement
- The current kit uses an upper two-piece sleeve, a lower stabilizer, stainless hardware, and the mast protective/bottom cap identified in the mast guide.
- Choose the PORTA-MOUNT separately for the actual vehicle or structure.
- The reducer does not increase the mast load, height, or wind rating.
Recover without creating the next failure
- Inspect sleeve halves, lower stabilizer, protective cap, flange, and hardware.
- Remove grit from every mating surface.
- Keep the complete kit together.
- Replace distorted or missing parts; do not improvise shims.
Guying can stabilize a documented installation, but it does not increase the published load or make an unapproved support chain safe.
Use the current CHA 34HD REDUCER KIT instructions.
Open CFM34HD_3_Inch_Reducer_Sleeve_Quick_Start_260716.pdf · Open the product page
