Skip to content

Chameleon Knowledge Base · The Complete Online HF Antenna Handbook

CHA LEFS FEATHER Sloper Deployment Guide

CHA LEFS FEATHER sloper deployment succeeds when the operator reproduces the guide geometry instead of merely getting the wire into a tree.

Product Installation Guides CHA LEFS FEATHER Reviewed 2026-07-14
Start with the operator’s decision: CHA LEFS FEATHER sloper deployment succeeds when the operator reproduces the guide geometry instead of merely getting the wire into a tree.

How this exact system works

Raise the far-end line winder about 20–25 feet, keep the transformer around three feet above ground, allow some sag, and use the S-Biner and isolation ring for strain relief. The guide specifically recommends 15- or 25-foot RG-316 with its integrated choke and identifies CFM-16 as the tree-free lightweight support partner.

The boundary that prevents mistakes

Published power is 25 W SSB and 10 W CW or digital. The guide lists 40, 20, 15, and 10 meters without a tuner; 30, 17, 12, and the upper 10-meter FM segment require a tuner. This guide documents a sloper, not a generic horizontal/NVIS configuration.

Use this field sequence

Survey the support and fall line, lay out and inspect the full radiator, strain-relieve the feed system, raise it without excessive tension, route the coax away from foot traffic, then verify the installed antenna before transmitting.

Source boundary

CHA LEFS FEATHER Operator’s Manual, Rev. 3/30/2026. The exact current product, components, band, feed, support, geometry, and operating limits control; physical fit does not establish compatibility.

Continue learning

Back to the Knowledge Base
Back to top