MORGAN SYSTEMS M-309 OPEN WIRE/BALANCED LINE ARRESTOR · Accessories & Components
A replacement, service, interface, or modular accessory for a documented product or system.
Why operators make room for it
Solve the interface problem before it stops the deployment
A dependable station often comes down to the adapter, fastener, or component packed before the operator leaves the workbench.
That is where MORGAN SYSTEMS M-309 OPEN WIRE/BALANCED LINE ARRESTOR enters the kit. Model 309 is designed for use with open wire balanced feed systems such as ladder line, window line, twinlead, etc. It is compatible up to it’s design power rating with a wide variety of input impedances / reactances ranging from about 300 ohms to 600 ohms Like all arrestor protection units these circuits are designed to be ground-mounted and should be installed close to earth entry point connections for best results.
The operator gets a specific way to complete, adapt, or maintain the intended product without confusing physical fit with full RF, power, environmental, or structural compatibility.
Quick product reference
Key Specifications
- Product type
- Accessories & Components
- Primary role
- A replacement, service, interface, or modular accessory for a documented product or system.
- Frequency Range
- 1-30 MHz
- Impedance
- 300-600 ohms
- Selection rule
- Confirm product family, revision, interface, size, and quantity
- Compatibility
- Verify electrical, power, and structural requirements where applicable
- Component role
- Replacement
- service
- interface
- or modular part for a documented product or system
- Selection checks
- Confirm product family, revision, interface, material, size, and quantity
Operator decision support
Plan the complete setup
See what this product is best suited for, what the documented setup needs, and the boundaries to confirm before deployment.
- Best for
A dependable station often comes down to the adapter, fastener, or component packed before the operator leaves the workbench.
- What else you need
Confirm product family, revision, interface, size, and quantity
- Compatible with
Verify electrical, power, and structural requirements where applicable
What an operator can do
- Confirm the exact product, revision, interface, size, quantity, and position the component is intended to serve.
- Install it according to the completed product or system guide.
- Treat physical fit as only one part of compatibility; verify electrical, power, and structural requirements where applicable.
Complete product details
For transmitting or receiving applications using open-wire fed systems in single wire or parallel balanced lines, these arrestors use our patented technology in larger housings with insulated terminals. These units are constructed in metallic aluminum chassis cases.
Model 309 is designed for use with open wire balanced feed systems such as ladder line, window line, twinlead, etc. It is compatible up to it’s design power rating with a wide variety of input impedances / reactances ranging from about 300 ohms to 600 ohms Like all arrestor protection units these circuits are designed to be ground-mounted and should be installed close to earth entry point connections for best results. Compatible with both split capacitor type antenna tuner and balun output stages common in modern antenna tuning products.
All units use toroidal inductors and present near dead DC short on antenna side of arrestor, constantly draining feedline wires of static and any developed voltage potential feedthrough breakdown voltage from input ports to output ports 4,000 to 6,000 volts. Arrestor units may be placed anywhere in the feedline at ground level without serious change in tuning, but small change may be detectable due “to small” increase in total feedline length caused by size of arrestor case & circuit.
Models 308 and 309 series all rated for frequency range 1-30 MHz, non-DC continuous through ports, polarized. Units 308 & 309 are constructed in aluminum cases with a mounting footprint of 4"x2", 1.875" tall. Units include a 2 page owner’s manual.
Specifications
- Model: M-309
- Frequency Range: 1-30 MHz
- Impedance: 300-600 ohms
- Power handling: 1KW PEP/500W CSS
- Connector types: Screw terminals
- Uses: Protection of transmit/receive equipment using balanced line.
